Features-ISI Certified Helmets

We have used lot of curvatures all around and tested them in our CAD software to take on maximum impact without breaking. Not only the design, we have made sure that the helmet shell is moulded with imported high pressure injection moulding machines for consistent quality.

We only use High Impact Acrylonitrile butadiene styrene (High Impact ABS) material.

It is made out of high density thermocol which absorbs most of the energy of the impact.

The retention system is made of  high quality fabrics and plastics.

Thick, clear and tough polycarbonate material with UV protection is used. It is coated with hard silicone layer to protect  it from scratches.

It is made of most clear and tough polycarbonate material.

EPDM seals are used to protect the LED and electrical system from water.

We use high end Lithium ion batteries which are safest batteries till date.

A 2 hour charge gives a battery back-up of 9 hours. A USB Cable is provided to charge which can be plugged into a mobile charging system.

The on off switch along with the charging point at the back are well covered with a good quality EPDM cover to protect it from water during rains. 

There is an external battery management system which shuts off power supply when the battery is low on charge and when it reaches 100 % charge to increase battery life and ensures safety.

This helmet is equipped with a special circuit which gives a balanced current output and about 1500  recharge cycles.